What's in the Water in Baltimore, MD?
Monitoring data for Baltimore, Maryland shows 3 distinct contaminants detected in the public water supply — Haloacetic Acids (HAA5), Nitrate, E. coli (RTCR). Of these, 1 exceeded the EPA Maximum Contaminant Level.
Contaminants Detected in Baltimore
| Contaminant | Detected | EPA Limit (MCL) | Status |
|---|---|---|---|
| Haloacetic Acids (HAA5) | 63 ug/l | 60 ug/l | Exceeds limit |
| Nitrate | 5 ppm | 10 ppm | Within limit |
| E. coli (RTCR) | 0 presence | 0 presence | Within limit |
Detected levels are the highest reported across Baltimore systems for each contaminant. MCL = EPA Maximum Contaminant Level, the legal safety ceiling. Source: EPA SDWIS monitoring data.
Safety & Violations
| Metric | Value |
|---|---|
| Average Safety Score | 44/100 (F worst) |
| Public Water Systems | 1 |
| Population Served | 1,600,000 |
| Health Violations | 3 |
| Monitoring Violations | 0 |
| Contaminant Exceedances | 1 |
| Enforcement Actions | 38 |
Frequently Asked Questions
Monitoring data for Baltimore, Maryland shows 3 distinct contaminants detected in the public water supply — Haloacetic Acids (HAA5), Nitrate, E. coli (RTCR). Of these, 1 exceeded the EPA Maximum Contaminant Level.
The 1 public water system serving Baltimore, Maryland (population 1,600,000) average a Water Safety Score of 44/100, with a worst grade of F. These systems have 3 health-based violations and 1 contaminant exceedance on record.
Baltimore, Maryland is served by 1 public water system, together supplying water to roughly 1,600,000 people. The worst safety grade among them is F.
Yes. 1 contaminant exceeded the EPA Maximum Contaminant Level (MCL) in Baltimore: Haloacetic Acids (HAA5). An exceedance means a detected level was higher than the legal safety limit at least once during monitoring.
The Water Safety Score (0-100, graded A-F) weighs health-based violations (40%), contaminant exceedances (30%), enforcement history (20%), and monitoring violations (10%), using EPA Safe Drinking Water Information System (SDWIS) data from the last 10 years.
Request your utility's annual Consumer Confidence Report (CCR), consider an independent test from a state-certified lab, and use an NSF-certified filter targeting any contaminant of concern. For lead specifically, run cold water 30 seconds before drinking.
More about Baltimore
Monitoring data for Baltimore, Maryland shows 3 distinct contaminants detected in the public water supply — Haloacetic Acids (HAA5), Nitrate, E. coli (RTCR). Of these, 1 exceeded the EPA Maximum Contaminant Level.
The data source behind this answer is the EPA Safe Drinking Water Information System (SDWIS). Every figure on the page traces back to that source; the methodology page describes the inputs and the refresh cadence in full detail.
A practical caveat: the headline answer above reflects the most recent the EPA Safe Drinking Water Information System (SDWIS) vintage; underlying data is often revised for months after first publication, and the right reference for any specific decision is whichever vintage is current at the time of the decision. The as-of date is stamped on every page.
Source: EPA Ground Water and Drinking Water, 2026.